In-Vehicle Crossbeam: Removal
NOTE:
Removal steps in this procedure may contain installation details.
- 1.WARNING: Before beginning any service procedure in this service information, refer to Safety Warnings in the General Information article. Failure to follow this instruction may result in serious personal injury.
Refer to: Health and Safety Precautions
- 2.
Remove the cowl panel grille. REFER to: Cowl Panel Grille
- 5.
Remove the instrument panel upper section. REFER to: Instrument Panel Upper Section
- 6.
Remove both front doors. REFER to: FRONT DOOR
- 12.
- Disconnect the electric connectors and detach the wiring harness retainers.
- Remove the screws and the air plenum bezel.
Torque
: 89 lb.in (10 Nm)
- 14.NOTE: To avoid damaging the in-vehicle cross beam, an assistant is required when carrying out the following steps.NOTE: Remove the bolts from one side completely and support the in-vehicle cross beam before removing the bolts from the opposite sideNOTE: Make sure that all electrical connectors and wiring are not hindered before removing the in-vehicle cross beam or damage to the components may occur.
With the help of an assistant. Remove the bolts and the in-vehicle crossbeam from the vehicle.
Torque
: 18 lb.ft (25 Nm)