DTC Chart: BCM

BCM DTC Chart

DTC	Description	Action
B1098:11	Left Position Light: Circuit Short to Ground	GO to Pinpoint Test A
B1098:15	Left Position Light: Circuit Short to Battery or Open	If the lamp is inoperative, GO to Pinpoint Test A If the lamp is always on, GO to Pinpoint Test B
B1099:11	Right Position Light: Circuit Short to Ground	GO to Pinpoint Test A
B1099:15	Right Position Light: Circuit Short to Battery or Open	If the lamp is inoperative, GO to Pinpoint Test A If the lamp is always on, GO to Pinpoint Test B
B109B:11	License Plate Light: Circuit Short to Ground	GO to Pinpoint Test A
B109B:15	License Plate Light: Circuit Short to Battery or Open	If the lamp is inoperative, GO to Pinpoint Test A If the lamp is always on, GO to Pinpoint Test B
U1000:00	Solid State Driver Protection Active -Driver Disabled: No Sub Type Information	The module has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The BCM cannot enable the output until the cause of the short is corrected. ADDRESS all other Diagnostic Trouble Codes (DTCs) first. After the cause of the concern is corrected, CLEAR the Diagnostic Trouble Codes (DTCs). REPEAT the self-test. For additional information on BCM Field Effect Transistor (FET) protection, REFER to: Module Controlled Functions - System Operation and Component Description
U3000:49	Control Module: Internal Electronic Failure	The module has permanently disabled an output because an excessive current draw fault (such as a short to ground) has exceeded the limits that the BCM can withstand. The cause of the excessive current draw MUST be corrected before a new BCM is installed. ADDRESS all other Diagnostic Trouble Codes (DTCs) first. After the cause of the concern is corrected, INSTALL a new BCM. REFER to: BODY CONTROL MODULE (BCM) For additional information on BCM Field Effect Transistor (FET) protection, REFER to: Module Controlled Functions - System Operation and Component Description