Coolant Pump: Removal

WARNING: This page is about a different variant/trim than selected.

1.

WARNING: Before beginning any service procedure in this service information, refer to Safety Warnings in GENERAL INFORMATION . Failure to follow this instruction may result in serious personal injury.

Refer to: Engine Cooling System Health and Safety Precautions .

2.

Drain the cooling system. REFER to: Cooling System Draining, Vacuum Filling and Bleeding .

3.

NOTE: If equipped.

Remove the retainers and the underbody shield.

GFD64681

Courtesy of FORD MOTOR COMPANY

4.

Release the tabs and position the degas bottle aside.

GFD64682

Courtesy of FORD MOTOR COMPANY

5.
- 1.
  
  Unclip the A/C line from the support bracket.
- 2.
  
  Remove the A/C support bracket.

GFD64683

Courtesy of FORD MOTOR COMPANY

6.

Remove the engine mount bolts.

GFD64684

Courtesy of FORD MOTOR COMPANY

7.

Position a floor jack to support the engine.
Use the General Equipment: Trolley Jack

GFD60881

Courtesy of FORD MOTOR COMPANY

8.

Loosen the coolant pump pulley bolts. Loosen: 2 turn(s)

GFD64685

Courtesy of FORD MOTOR COMPANY

9.

NOTE: Position the accessory drive belt so no coolant will drip on the belt, or the belt may be contaminated.
- 1.
  
  Using a suitable tool retract the accessory drive belt tensioner.
- 2.
  
  Position aside the accessory drive belt.
- 3.
  
  Release the accessory drive belt tensioner.

GFD64686

Courtesy of FORD MOTOR COMPANY

10.

Remove the bolts and the accessory drive belt tensioner.

GFD64687

Courtesy of FORD MOTOR COMPANY

11.

Remove the bolts and the coolant pump pulley.

GFD64688

Courtesy of FORD MOTOR COMPANY

12.

Remove the bolts and the coolant pump. Discard the O-ring seal.

GFD64689

Courtesy of FORD MOTOR COMPANY