Halfshaft Seal LH: Installation

WARNING: This page is about a different variant/trim than selected.

1.

NOTE: Make sure a new component is installed.

GFD62691

Courtesy of FORD MOTOR COMPANY

2.

Use Special Service Tool: 205-115A (205-115) Installer, Drive Pinion Seal.

GFD62692

Courtesy of FORD MOTOR COMPANY

3.

NOTE: Make sure that the strut is not moved more than necessary to prevent damage to top mount.

NOTE: The inner constant velocity (CV) joint must not be bent more than 18 °.

NOTE: The outer constant velocity (CV) joint must not be bent more than 45 °.

NOTE: Take extra care not to damage the seal.
- 1.
  
  Use Special Service Tool: 205-775 Protector, Halfshaft Seal.

GFD62693

Courtesy of FORD MOTOR COMPANY

4.

NOTE: Take extra care not to damage the seal.

Remove the special tool before completely installing the halfshaft. Remove Special Service Tool: 205-775 Protector, Halfshaft Seal.

GFD62694

Courtesy of FORD MOTOR COMPANY

5.

Remove Special Service Tool: 204-609 Protection Cap, Ball Joint Gaiter.

GFD62457

Courtesy of FORD MOTOR COMPANY

6.

GFD62456

Courtesy of FORD MOTOR COMPANY

7.

Use Special Service Tool: 204-605 Separator, Lower Arm Ball Joint.

GFD62695

Courtesy of FORD MOTOR COMPANY

8.

NOTE: Make sure a new bolt is installed.

NOTE: Make sure a new nut is installed.

Torque: 61 lb.ft (83 Nm)

GFD62686

Courtesy of FORD MOTOR COMPANY

9.

Torque: 89 lb.in (10 Nm)

GFD60548

Courtesy of FORD MOTOR COMPANY

10.

If equipped.
Torque: 71 lb.in (8 Nm)

GFD62454

Courtesy of FORD MOTOR COMPANY

11.

Refer to: Transmission Fluid Level Check .

12.

Install engine undershield - If equipped.

13.

Refer to: Wheel and Tire .