Input Shaft: Disassembly
WARNING: This page is about a different variant/trim than selected.
- 1.
Using the bearing separator and a hydraulic press, remove and discard the bearing. Use the General Equipment: Hydraulic Press Use the General Equipment: Bearing Separator
- 2.
Using the bearing separator and a hydraulic press, remove and discard the bearing. Use the General Equipment: Hydraulic Press Use the General Equipment: Bearing Separator
- 4.
Using the bearing separator and a hydraulic press, Remove the 4th gear. Use the General Equipment: Hydraulic Press Use the General Equipment: Bearing Separator
- 5.
Remove the 3rd gear, the needle bearing and the 3rd gear synchronizer ring. Remove and discard the snap ring.
- 7.NOTE: The detent balls are spring-loaded. Take care when removing the selector ring from the synchronizer hub.NOTE: Mark the installed position of the selector ring.
Disassemble the following items:
- 1.
Selector ring
- 2.
Synchronizer body
- 3.
Compression springs
- 4.
Blocker bars
- 5.
Detent balls
- 1.