Input Shaft: Assembly
WARNING: This page is about a different variant/trim than selected.
- 1.NOTE: Do not lubricate new roller bearings.
Lubricate all other transmission components with transmission fluid during reassembly.
Material: Motorcraft ® Dual Clutch Transmission Fluid / XT-11-QDC (WSS-M2C200-D2)
- 2.NOTE: Observe the markings on the selector ring.
Assemble the following items:
- 1.
Compression springs
- 2.
Blocker bars and detent balls
- 3.
Selector ring
- 1.
- 5.NOTE: Use a tube to press the gear on.
Install the 4th gear. Use the General Equipment: Hydraulic Press
- 6.
Install the following items:- Install a new snap ring.
- Install a new bearing. Use the General Equipment: Hydraulic Press
NOTE: Using a tube, press the bearing on by the inner race only.NOTE: The roller bearing must not be lubricated.
- 7.NOTE: Using a tube, press the bearing on by the inner race only.NOTE: The roller bearing must not be lubricated.
Install a new bearing. Use the General Equipment: Hydraulic Press