Pinpoint Test B : Poor Image Quality: Notes
WARNING: This page is about a different variant/trim than selected.
Poor Image Quality
Refer to Wiring Diagrams PARKING AID for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Parking Aid - System Operation and Component Description
Possible Sources
- Dirty or scratched camera lens
- Wiring, terminals or connectors
- Rear parking aid camera
- FCDIM
- APIM
- Interference from other sources
Visual Inspection and Diagnostic Pre-Checks
- Make sure the rear parking aid camera lens is clear of any debris.
- If the vehicle is equipped with an 8 in (203 mm) touchscreen display, PERFORM an APIM reset and reevaluate the concern prior to following this pinpoint test. REFER to: RESET THE SYNC MODULE [APIM]
NOTE:
Before disconnecting the camera, verify the connector is properly seated and latched.