Transmission Draining and Filling

WARNING: This page is about a different car, the 2016 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.

Special Tool(s) / General Equipment

Fluid Suction Gun

Materials

Name	Specification
Motorcraft® Dual Clutch Transmission Fluid XT-11-QDC	WSS-M2C200-D2

Draining

1.

With the vehicle in NEUTRAL, position it on a hoist. REFER to: Jacking and Lifting - Overview

2.

Remove the underbody shield.

GFD61483

Courtesy of FORD MOTOR COMPANY

3.

Drain the transmission.
Torque: 30 lb.ft (40 Nm)

GFD62863

Courtesy of FORD MOTOR COMPANY

Filling

1.

Remove the fill plug.

GFD62864

Courtesy of FORD MOTOR COMPANY

2.

Fill the transmission through the fill hole until it is level with the bottom of the fill hole.
Material: Motorcraft® Dual Clutch Transmission Fluid / XT-11-QDC (WSS-M2C200-D2)

GFD62865

Courtesy of FORD MOTOR COMPANY

3.

Drain fluid from the fill hole. Use the General Equipment: Fluid Suction Gun
Volume: 0.53 qt (500 ml)

GFD62866

Courtesy of FORD MOTOR COMPANY

4.

Install the fill plug.
Torque: 30 lb.ft (40 Nm)

GFD62864

Courtesy of FORD MOTOR COMPANY

5.

Install the underbody shield.

GFD61488

Courtesy of FORD MOTOR COMPANY