Fuel Tank Filler Pipe: Removal
WARNING: This page is about a different car, the 2016 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Removal steps in this procedure may contain installation details.
- 1.
With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
- 2.
Disconnect the battery ground cable. Refer to: Battery Disconnect and Connect .
- 3.
-
NOTE: The supplemental refueling adapter is located in the luggage compartment.NOTE: If the fuel tank is completely full, this step will lower the fuel level to the fuel tank inlet.
Install the supplemental refueling adapter and a length of semi-rigid fuel drain tube into the Easy Fuel (capless) fuel tank filler pipe.
- Attach the Fuel Storage Tanker to the fuel drain tube and remove any residual fuel in the fuel tank filler pipe. Use Special Service Tool: 292-00004 Fuel Tanker 100 GPM.
-
- 5.
Remove the RHR wheel and tire. Refer to: Wheel and Tire .
- 8.
Disconnect the EVAP tube assembly-to-fuel tank filler pipe recirculation tube quick connect coupling. Refer to: Quick Release Coupling .
- 9.
Release the clamp and disconnect the fuel tank filler pipe from the fuel tank.Torque: 35 lb.in (4 Nm)
- 10.
Disconnect the retainers, remove the bolts and the fuel tank filler pipe from the vehicle.Torque: 89 lb.in (10 Nm)