Operating with Memory Set Switch

The pedals can be adjusted using the memory SET switch with the ignition in OFF, ON, ACC or RUN; but the gear selector must be in the PARK position. When one of the memory set positions is recalled by pressing the memory set switch, the DSM senses continuity to ground through the memory set switch circuit and sends a message to the BCM over the MS-CAN. The BCM acts as a gateway module and transmits the message to the SCCM over the HS-CAN. The SCCM then provides voltage to the adjustable pedal motor to move the pedals.

The SCCM monitors the Hall-effect sensor in the adjustable pedal motor and stops sending voltage to the motor when the required pedal position is reached. If the SCCM receives a pedal position input from the adjustable pedals control switch during a memory position recall, the module stops the memory recall and responds to the new pedal position input.

For information on setting and recalling a memory pedal position, refer to Memory Position Programming in Seating .