Pinpoint Test K : The AWD Gauge Is Inoperative (If Equipped)

K1 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST

Are any DTCs recorded?

Yes	REFER to DTC Chart - IPC in DTC Chart(s)
No	GO to K2.

K2 RETRIEVE THE RECORDED DTCs FROM THE PCM KOEO SELF-TEST

Are any DTCs recorded?

Yes	REFER to ENGINE CONTROLS - SYMPTOM CHARTS (EXCEPT DIESEL & HYBRID)
No	GO to K3.

K3 CHECK THE DISPLAY MODE MENU

On the optional IPC, in the display mode menu, press the LH steering wheel switch to the right to display the AWD gauge.

On the base IPC, in the Information display mode, press the LH steering wheel switch to the right then down to display the AWD gauge.

Does the AWD gauge display?

Yes	The AWD gauge is operating correctly at this time. The display mode was not set to correct display mode.
No	INSTALL a new IPC. REFER to Instrument Panel Cluster (IPC) .