Pinpoint Test AQ : The Turn/Hazard On Warning Chime Is Inoperative
- AQ1 CHECK THE SAFETY BELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Monitor the safety belt warning chime when the ignition switch is transitioned from OFF to RUN for 6 seconds.
Does the safety belt warning chime operate for approximately 6 seconds?
Yes GO to AQ2. No INSTALL a new IPC. REFER to Instrument Panel Cluster (IPC) . - AQ2 CHECK THE TURN SIGNAL INDICATOR OPERATION
- Ignition ON.
- Verify the RH and LH turn signal indicators operate correctly.
Do the turn signal indicators operate correctly?
Yes GO to AQ3. No GO to Pinpoint Test S . - AQ3 RETRIEVE THE RECORDED DTCs FROM THE BCM SELF-TEST
- Ignition ON.
- Using a scan tool, perform the BCM self-test.
Are any DTCs present?
Yes REFER to the BCM DTC Chart in Multifunction Electronic Modules . No INSTALL a new IPC. REFER to Instrument Panel Cluster (IPC) .