Fuel System Pressure Release

Fuel System Pressure Release 

Pressure release 

• 1.
  
  
  NOTE: The fuel pump relay fuse is located in the BJB, location F11.

  Remove the fuel pump relay fuse.

• 2.
  
  
  NOTE: It may take up to several minutes before the engine stalls.

  Start the engine and allow it to idle until the engine stalls.

• 3.
  
  Crank the engine an additional 20 seconds to make sure the fuel system pressure has been released.

• 4.
  
  Turn the ignition switch to the off position.

• 5.
  
  When the fuel system service is complete, install the fuel pump relay fuse.

• 6.
  
  
  NOTE: It may take more than one key cycle to pressurize the fuel system

  Cycle the ignition key and wait 3 seconds to pressurize the fuel system. Check for leaks before starting the engine.