DTC Chart: Body Control Module (BCM)

Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. For information about these practices, REFER to: Diagnostic Methods .

BCM DTC Chart

DTC	Description	Action
B1249:12	Start Button Illumination: Circuit Short To Battery	GO to Pinpoint Test E
B1249:14	Start Button Illumination: Circuit Short To Ground or Open	GO to Pinpoint Test E
U1000:00	Solid State Driver Protection Activated - Driver Disabled: No Sub Type Information	The BCM has temporarily disabled an output because an excessive current draw exists (such as a short to ground). When this DTC is stored in the BCM, the illumination output driver is disabled until the cause of the excessive current draw has been corrected and a successful self-test has been performed. ADDRESS all other BCM Diagnostic Trouble Codes (DTCs) first. After the cause of the concern has been corrected, CLEAR the DTC and PERFORM the BCM self-test.
U2010:11	Switch Illumination: Circuit Short to Ground	GO to Pinpoint Test B
U2010:15	Switch Illumination: Circuit Short to Battery or Open	If one or more non-networked illumination source is inoperative, GO to Pinpoint Test B If one or more non-networked illumination source is always on, GO to Pinpoint Test H
U3000:49	Control Module: Internal Electronic Failure	The BCM has permanently disabled an output because an excessive current draw exists (such as a short to ground) that has exceeded the limits of what the BCM can withstand. ADDRESS all other BCM Diagnostic Trouble Codes (DTCs) first. After the cause of the concern has been corrected, INSTALL a new BCM. REFER to: Body Control Module (BCM) .
All other DTCs	-	REFER to: Body Control Module (BCM) .