Transport and Factory Mode Deactivation

Deactivation 

1. 1.
   
   Place the ignition in the OFF position.

1. 2.
   
   Verify the battery is fully charged. Refer to: Battery .

1. 3.
   
   
   NOTE: On vehicles with Push-Button Start, place a programmed passive key in the PATS backup starting location.

   Place the ignition in the ON position.

1. 4.
   
   
   NOTE: Steps 4 and 5 must be carried out within 10 seconds.

   Press and release the brake pedal 5 times.

1. 5.
   
   Press and release the hazard switch 2 times (on, off).

1. 6.
   
   
   NOTE: When exiting Factory mode, the IPC message center indicates NORMAL MODE when the procedure has been successfully completed.

   Place the ignition in the OFF position.