Turbocharger Oil Supply Tube RH: Installation

1.

Install the new turbocharger oil supply tube O-ring seals and the new turbocharger oil supply tube oil filter. Lubricate the O-ring seals with clean engine oil. Refer to: SPECIFICATIONS - 2.7L EcoBoost (238kW/324PS).

GFD16722

Courtesy of FORD MOTOR COMPANY

2.

NOTE: Carefully use a nylon brush to remove the old O-ring residue and use brake cleaner to rinse the O-ring residue out of the turbocharger tube to turbocharger O-ring bore and the turbocharger tube to engine O-ring bore. Inspect the area for deep scratches and gouges. DO-NOT USE A METAL BRUSH; DAMAGE TO SEALING AREA WILL RESULT IN LEAKS.

NOTE: When installing the turbocharger oil supply tube into the engine block, use care not to damage the new turbocharger oil supply tube oil filter.

Install the turbocharger oil supply tube, then install and tighten the turbocharger oil supply tube bolts.

Material

: Metal Brake Parts Cleaner (U.S.) / PM-4-A, PM-4-B (U.S.)

Torque

: 89 lb.in (10 Nm)

GFD16703

Courtesy of FORD MOTOR COMPANY

3.

Install the lower RH - CAC intake pipe and then tighten the clamps.
Torque

: 44 lb.in (5 Nm)

GFD19651

Courtesy of FORD MOTOR COMPANY

4.

Install the lower air cleaner outlet pipe RH. Refer to: AIR CLEANER OUTLET PIPE RH .

5.

If equipped, install the underbody shields and the retainers.

GFD16036

Courtesy of FORD MOTOR COMPANY

6.

Install the underbody shields and the retainers.

GFD16448

Courtesy of FORD MOTOR COMPANY

7.

Install the RH front tire. Refer to: Wheel and Tire .

8.

Install the engine appearance cover, then install and tighten the engine appearance cover retainers.
Torque:

1: 42 lb.in (4.8 Nm)

2: 97 lb.in (11 Nm)

GFD19564

Courtesy of FORD MOTOR COMPANY

9.

Check and top off the engine oil level as needed. Refer to: SPECIFICATIONS - 2.7L EcoBoost (238kW/324PS).