LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2014 >> Mustang Base, 2D Coupe, Standard Trans >> Labor Times >> Other Variant >> Brakes >> Mechanical - Hydraulic >> Brake Shoes &/Or Pads >> Remove & Replace

Brake Shoes &/Or Pads: Remove & Replace

WARNING: This page is about the Mustang Base, 2D Convertible, Automatic Trans, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.

Applies ToNoteStandard HoursWarranty HoursSkill Level
All1.8B
Front or Rear1.0B
Combination Procedure: BRAKE HOSE: Replace:
Each AdditionalIncludes: Bleed Brakes.0.2B
OneIncludes: Bleed Brakes.0.8B
Combination Procedure: CALIPER: Replace:
OneIncludes: Bleed Brakes.0.7B
Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle:
0.5B
Combination Procedure: DISC ROTOR: Remove and Install for Refinishing:
NOTE: This operation does not apply to drive axles. If on vehicle refinishing is not possible use appropriate repair operation.
Front,Each0.4B
Combination Procedure: DISC ROTOR: Replace:
Each0.1B
Combination Procedure: WHEEL BEARING: Replace:
Front,BothServiced with Wheel Hub Assembly.B
Front,One SideServiced with Wheel Hub Assembly.B
Rear,Both,w/Limited Slip1.9B
Rear,Both,w/o Limited Slip1.8B
Rear,One Side,w/Limited Slip1.4B
Rear,One Side,w/o Limited Slip1.3B
Combination Procedure: WHEEL HUB: Replace:
Front,Both1.0B
Front,One Side0.7B
Combination Procedure: WHEEL SEAL: Replace:
Rear,Both,w/Limited Slip1.3B
Rear,Both,w/o Limited Slip1.2B
Rear,One Side,w/Limited Slip1.1B
Rear,One Side,w/o Limited Slip1.0B