LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2014 >> Fusion Titanium, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 65 (Parking Brake System - Parking Brake & Actuation -- (Hybrid)) >> General Procedures >> Electronic Parking Brake (EPB) Service Mode Activation and Deactivation >> Deactivation

Electronic Parking Brake (EPB) Service Mode Activation and Deactivation: Deactivation

WARNING: This page is about a different variant/trim than selected.
NOTE: Carry out the following service mode deactivation procedure to activate the EPB  system.
  1. Set the ignition to ON.
  2. Press and hold the accelerator pedal and place the EPB  switch in the APPLY (upward) position. Continue to hold the accelerator pedal and the EPB  switch.
  3. Set the ignition to OFF then set the ignition to ON within 5 seconds.  Continue to hold the accelerator pedal and the EPB  switch.
  4. NOTE: The EPB  system will fully apply and release the parking brake to guarantee sufficient air gap between the rear brake pads and brake disc.

    Release the accelerator pedal and the EPB  switch.

scientia non olet · About LEMON Manuals