Pinpoint Test E : The Roof Opening Panel Does Not Open Or Close: Notes

WARNING: This page is about a different car, the 2015 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Refer to Roof Opening Panel for schematic and connector information.

The roof opening panel motor must be initialized when repairs are carried out on any part of the roof opening panel system or when the roof opening panel motor, glass, assembly, or air deflector has been removed or replaced for any reason. Refer to: Power Roof Opening Panel Initialization .

Normal Operation and Fault Conditions

The roof opening panel motor/module receives voltage from the accessory delay relay when the ignition is in the ACC or RUN position. The roof opening panel control switch (part of the overhead console) supplies ground signals to the roof opening panel motor/module to operate the roof opening panel. A failure in the power, ground, or control circuits, an internal failure of the switch or motor/module or a motor/module that has not been initialized all cause the roof opening panel to become inoperative.

Possible Sources

Fuses
Wiring, terminals or connectors
Roof opening panel motor/module assembly
Roof opening panel control switch (integral to the overhead console and is serviced as an assembly)
Accessory delay relay

Visual Inspection and Diagnostic Pre-checks

BCM fuse (27) (30A)
BCM fuse (31) (10A)