Switch and Controls

WARNING: This page is about a different car, the 2015 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

The roof opening panel control switch is integrated into the overhead console along with other controls and interior lights. The roof opening panel control switch is serviced as an assembly with the overhead console. The roof opening panel control switch is a touch-sensitive switch that has no motion or sound to indicate the switch has been activated. If the switch is touched between buttons it will not accept a command. When this happens, move your finger several inches away from the switch to allow the sensor system to reset and accept a new touch command.

When the roof opening panel glass is in the fully closed position, touching the roof opening panel control switch open symbol will activate the one-touch open feature. When in one-touch open mode (except vent), touching any roof opening panel control switch symbol will cancel the one-touch operation and place the glass at that specific position.

With the roof opening panel glass in any open position, touching the roof opening panel control switch close symbol will activate the one-touch close feature. When in one-touch close mode (except vent), touching any roof opening panel control switch symbol will cancel the one-touch operation and place the glass at that specific position. In vent one-touch open or close mode the one-touch operation will not manually cancel. Near the end of the forward travel, the rear portion of the roof opening panel glass moves upward on 2 lifter arms. This allows a weather-tight seal when the roof opening panel glass is closed.

If an obstacle contacts the leading edge of the roof opening panel glass during one-touch close operation, the roof opening panel glass will reverse direction and open to approximately the mid position and stop. The operator cannot stop this open motion once it has begun.

If an obstacle contacts the rear edge of the roof opening panel glass during one-touch vent close operation, the roof opening panel glass will reverse direction to the vent open position.

When the roof opening panel glass is in the closed position, touching the roof opening panel control switch vent symbol will activate the one-touch vent open feature. When the roof opening panel glass is in the vent position, touching the roof opening panel control switch close symbol will activate the one-touch vent close feature.