Component Tests: Thermostat

WARNING: This page is about a different car, the 2016 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Install a new thermostat only after at least one of the following tests and checks have been carried out:

Pinpoint Test B or C
Thermostat Visual Inspection

Thermostat Visual Inspection

1.

Remove the thermostat.

2.

Examine the thermostat for signs of damage including:

Valve not fully seated (light visible through the valve)
Foreign material lodged in the main valve
Bent or broken frame or flange
Bent or broken spring
Wax leaking from wax reservoir or a bulge in the reservoir
Any other damage or distortion

3.

NOTE: If no damage is found during the inspection, do not attempt to open the thermostat using hot water or other heat sources. This method is not an accurate means to test the function of the thermostat and may damage the thermostat.

If damage is found during the inspection, remove any foreign material or broken pieces and install a new thermostat.