Heated Steering Wheel Module (HSWM): Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
NOTE: This step is only necessary when installing a new component.NOTE: The PMI process must begin with the current HSWM installed. If the current HSWM does not respond to the diagnostic scan tool, the tool may prompt for As-Built Data as part of the repair.
Using a diagnostic scan tool, begin the PMI process for the HSWM following the on-screen instructions.
- Refer to: DRIVER KNEE AIRBAG .
- Torque:
22 lb.in (2.5 Nm)