Upper Arm: Removal

NOTE: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may result in major service expense. New parts must be installed with the same part numbers or equivalent part, if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.

WARNING: Before beginning any service procedure in this section, refer to Safety Warnings in GENERAL INFORMATION . Failure to follow this instruction may result in serious personal injury.

Refer to: HEALTH AND SAFETY PRECAUTIONS .
Refer to: SPRING .
Finger tight only.
Discard the specified component. Follow local disposal regulations.
NOTE: Fabricate a spacer.

NOTE: Focus, Focus-BEV and Focus-ST require different length spacers.
1. Focus, Focus-BEV.
2. Focus-ST.
Use the General Equipment: Transmission Jack
Discard the specified component. Follow local disposal regulations.
NOTE: Note the position of the upper control arm to aid installation.

Discard the specified component. Follow local disposal regulations.