Removal And Installation: Spring: Installation
- Visual check.
-
NOTE: Make sure that the spring is correctly located in both spring seats.
- Finger tight only at this stage.
- Use the General Equipment: Vehicle/Axle Stands
-
NOTE: Tighten the suspension bushing fasteners with the suspension loaded or with the weight of the vehicle resting on the wheels and tires, otherwise incorrect clamp load and bushing damage may occur.
Torque : 85 lb.ft (115 Nm)
-
NOTE: Tighten the suspension bushing fasteners with the suspension loaded or with the weight of the vehicle resting on the wheels and tires, otherwise incorrect clamp load and bushing damage may occur.
Torque : 35 lb.ft (48 Nm)
- Refer to: WHEEL AND TIRE .
- Refer to: REAR TOE ADJUSTMENT .