Rear Lower Arm: Installation

NOTE: Align the mark on the rearward lower control arm adjustment cam to the mark on the crossmember.

NOTE: Do not fully tighten the rearward lower control arm adjustment cam nut at this time.

Finger tight at this stage.
Refer to: SPRING .
Use the General Equipment: Vehicle/Axle Stands
NOTE: Tighten the suspension bushing fasteners with the suspension loaded or with the weight of the vehicle resting on the wheels and tires, otherwise incorrect clamp load and bushing damage may occur.

Torque : 66 lb.ft (90 Nm)
Refer to: REAR TOE ADJUSTMENT .