Pinpoint Test B : Poor Image Quality: Notes
WARNING: This page is about a different car, the 2015 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
Poor Image Quality
Refer to Wiring Diagrams PARKING AID for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Parking Aid - System Operation and Component Description
Possible Sources
- Dirty or scratched camera lens
- Wiring, terminals or connectors
- Rear parking aid camera
- FCDIM
- APIM
- Interference from other sources
Visual Inspection and Diagnostic Pre-Checks
- Make sure the rear parking aid camera lens is clear of any debris.
- If the vehicle is equipped with an 8 in (203 mm) touchscreen display, PERFORM an APIM reset and reevaluate the concern prior to following this pinpoint test. REFER to: RESET THE SYNC MODULE [APIM]
NOTE:
Before disconnecting the camera, verify the connector is properly seated and latched.