Pinpoint Test Bf: The Remote Key Programming Chime Is Inoperative

BF1 CHECK THE SAFETY BELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Monitor the safety belt warning chime when the ignition switch is transitioned from OFF to RUN for 6 seconds.
Does the safety belt warning chime operate for approximately 6 seconds?
1. Yes : GO to BF2
2. No : GO to PINPOINT TEST BJ
BF2 VERIFY REMOTE KEY PROGRAMMING
- Verify that the key programming can be successfully carried out.
Can the keys be programmed successfully?
1. Yes : GO to BF3
2. No : If not equipped with Intelligent Access (IA),
  REFER to: KEY PROGRAMMING USING TWO PROGRAMMED KEYS .
  
  REFER to: KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT .
  
  REFER to: KEY PROGRAMMING USING TWO PROGRAMMED KEYS .
  
  If equipped with Intelligent Access (IA),
  
  REFER to: ERASE ALL KEYS AND KEY PROGRAMMING .
  
  REFER to: KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT .
BF3 RETRIEVE THE RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST
- Using a scan tool, perform the IPC self-test.
Is DTC U0140:00 recorded?
1. Yes : GO to PINPOINT TEST AF
2. No : GO to BF4
BF4 RETRIEVE THE RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE BCM (BODY CONTROL MODULE) SELF-TEST
- Using a scan tool, perform a BCM self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
1. Yes : REFER to: BODY CONTROL MODULE (BCM) .
2. No : INSTALL a new BCM .
  REFER to: BODY CONTROL MODULE (BCM) .