Brake Fluid Reservoir: Removal

NOTE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.

NOTE: Removal steps in this procedure may contain installation details.

WARNING: Before beginning any service procedure in this service information, refer to Safety Warnings in GENERAL INFORMATION . Failure to follow this instruction may result in serious personal injury.

Refer to: HEALTH AND SAFETY PRECAUTIONS .
Refer to: BRAKE MASTER CYLINDER .
NOTE: Install new brake fluid reservoir seals. Lubricate the seals with clean, specified brake fluid.

Discard the specified component. Follow local disposal regulations.

Material : Motorcraft® DOT 4 LV High Performance Motor Vehicle Brake Fluid/PM-20 (WSS-M6C65-A2)