In-Vehicle Crossbeam: Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
WARNING: Before beginning any service procedure in this service information, refer to Safety Warnings in GENERAL INFORMATION . Failure to follow this instruction may result in serious personal injury.
Refer to: HEALTH AND SAFETY PRECAUTIONS .
- Remove the cowl panel grille.
Refer to: COWL PANEL GRILLE .
- Torque
: 18 lb.ft (25 Nm)
- Remove the instrument panel upper section.
Refer to: INSTRUMENT PANEL UPPER SECTION .
- Remove both front doors.
Refer to: FRONT DOOR .
- On both sides.
Torque : 30 lb.ft (40 Nm)
- Torque
: 18 lb.ft (25 Nm)
- Torque
: 89 lb.in (10 Nm)
- Torque
: 18 lb.ft (25 Nm)
-
NOTE: To avoid damaging the in-vehicle cross beam, an assistant is required when carrying out the following steps.NOTE: Remove the bolts from one side completely and support the in-vehicle cross beam before removing the bolts from the opposite sideNOTE: Make sure that all electrical connectors and wiring are not hindered before removing the in-vehicle cross beam or damage to the components may occur.
Remove the in-vehicle cross beam from the vehicle.
Torque : 18 lb.ft (25 Nm)