Roll Restrictor RH: Installation

WARNING: This page is about a different car, the 2016 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.

1.

Install the roll restrictor and the bolts and tighten in sequence shown below.
Torque:

Stage 1: 35 lb.ft (48 Nm)

Stage 2: 92 lb.ft (125 Nm)

Fig 1: Roll Restrictor Tightening Sequence

Courtesy of FORD MOTOR COMPANY

2.
- 1.
  
  Install the underbody shield.
- 2.
  
  Install the air deflector.

Courtesy of FORD MOTOR COMPANY