Parking Brake Cable Adjustment - Vehicles With: Rear Disc Brakes: Activation

Use the General Equipment: Interior Trim Remover
Refer to: JACKING AND LIFTING - OVERVIEW .
NOTE: Make sure the parking brake control is fully released.

NOTE: This step requires the aid of another technician.
1. Insert a 0.7 mm feeler gauge between the parking brake lever and the brake caliper abutment, on both sides.
2. Tighten the parking brake cable adjustment nut until movement is observed on one of the parking brake levers.
3. Remove the feeler gauges.
Torque : 18 lb.in (2 Nm)
Use the General Equipment: Interior Trim Remover