Pinpoint Test Al: The Headlamps On Warning Chime Is Inoperative

• Ignition OFF.
• Ignition ON.
• Monitor the safety belt warning chime when the ignition switch is transitioned from OFF to RUN for 6 seconds.

Does the safety belt warning chime operate for approximately 6 seconds? 

• Yes  : GO to AL2  .
• No  : INSTALL a new IPC  . REFER to INSTRUMENT PANEL CLUSTER (IPC) .

• Open and close the driver door.
• Observe the interior lamps.

Do the interior lamps operate correctly from the driver door? 

• Yes  : For vehicles without IA  , GO to AL3  .

  For vehicles with IA  , GO to  AL4.

• No  : REFER to INTERIOR LIGHTING .

• Ignition OFF.
• Insert the key into the ignition lock cylinder.
• Open the LH front door and observe the key-in-ignition warning chime operation.

Does the key-in-ignition warning chime operate correctly? 

• Yes  : GO to AL4  .
• No  : INSTALL a new IPC  . REFER to INSTRUMENT PANEL CLUSTER (IPC) .

• Using a scan tool, perform the IPC  self-test.

Are any DTCs recorded? 

• Yes  : For DTC U0140:00, GO to PINPOINT TEST AW .

  For all other DTCs, REFER to DTC CHART - IPC  in this article.

• No  : GO to AL5  .

• Check for recorded BCM  DTCs from the self-test.

Are any DTCs recorded? 

• Yes  : REFER to the BCM  DTC Chart in DTC Chart .
• No  : INSTALL a new BCM  . REFER to Body Control Module (BCM)Body Control Module (BCM) . TEST the system for normal operation.