LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2014 >> Flex SEL, FWD >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Rear Disc Brake System >> Removal And Installation >> Rear Brake Caliper Anchor Plate >> Removal

Rear Brake Caliper Anchor Plate: Removal

WARNING: Before beginning any service procedure in this service information, refer to Safety Warnings in SERVICE INFORMATION . Failure to follow this instruction may result in serious personal injury.
NOTE: Removal steps in this procedure may contain installation details.
  1. Remove the brake pads. For additional information, refer to BRAKE PADS .
  2. Discard the specified component. Follow local disposal regulations.
    • To install, tighten to 103 Nm (76 lb-ft).
      G08624611