Front Brake Flexible Hose: Removal

WARNING: Before beginning any service procedure in this service information, refer to Safety Warnings in SERVICE INFORMATION . Failure to follow this instruction may result in serious personal injury.

NOTE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.

NOTE: Do not allow grease, oil, brake fluid or other contaminants to contact the pad lining material, or damage to components may occur. Do not install contaminated pads.

NOTE: Removal steps in this procedure may contain installation details.

NOTE:

With the vehicle in NEUTRAL, position it on a hoist. For additional information, REFER to JACKING & LIFTING .

NOTE: Make sure to protect the brake pads from contamination from the brake fluid during the brake flexible hose installation and the brake caliper bleeding.

To install, tighten the brake tube fitting to 17 Nm (150 lb-in).

To install, tighten the brake flexible hose bracket bolt to 30 Nm (22 lb-ft).

Discard the specified component. Follow local disposal regulations.

To install, tighten to 47 Nm (35 lb-ft).