LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2014 >> Flex SEL, FWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Seat System - Seats >> Diagnosis And Testing >> Seating >> Pinpoint Tests >> Pinpoint Test S: The Power Seat is Inoperative - Second Row, Power-Fold Seat Does Not Latch to the Floor >> Normal Operation

Normal Operation

Each second row power-fold seat receives battery voltage from the Body Control Module (BCM) at all times. The power-fold seat motors contain internal switching that operate the motor until it moves to the reset position and turns off. The demand lighting/battery saver voltage output circuit from the BCM  provides the control signal voltage to each seat control switch. The seat control switches are momentary contact switches when pressed and held for at least one second supply switched voltage to the power-fold seat motor control circuit to initiate a pull and release cycle. The power-fold seat motor retracts a release cable connected to the same mechanical release lever in the seat latch mechanism as the manual release pull strap. When the power-fold seat motor is cycled, the pull strap retraction and release/reset is noticeable.

This pinpoint test is intended to diagnose the following: 

scientia non olet · About LEMON Manuals