LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2014 >> Flex SEL, FWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Handles, Locks, Latches And Entry Systems (With Intelligent Access) >> Diagnosis And Testing >> Handles, Locks, Latches and Entry Systems >> Pinpoint Tests >> Pinpoint Test S: DTCs B106E, B106F >> PINPOINT TEST S: DTCs B106E, B106F

PINPOINT TEST S: DTCs B106E, B106F

  1. S1 REVIEW THE DTCs 
    NOTE: First follow the necessary diagnostics to resolve DTC B106E and any other present DTCs (ignoring B106F). DTC B106E is only present when there is another DTC due to software or circuitry issues that must be resolved before another self-test is run. DTC B106F is only present once the final threshold has been met. Failure to correct the fault condition first may cause damage to the new DDM  , resulting in a repeat repair.
    • Review the DTCs from the DDM  self-test.

    Are any other DTCs present, besides B106E, B106F or B1342? 

  2. S2 REPEAT THE DDM SELF-TEST 
    • Ignition ON.
    • Using a scan tool, clear the DTCs and repeat the DDM  self-test.

    Is DTC B106F or DTC B1342 present? 

    • Yes  : INSTALL a new DDM  . REFER to DRIVER DOOR MODULE (DDM) .
    • No  : The system is operating correctly at this time. The circuit short has been repaired.
scientia non olet · About LEMON Manuals