LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2014 >> Flex SEL, FWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System & Washer System >> Removal And Installation >> Washer Pump and Reservoir >> Removal and Installation

Removal and Installation

NOTE: Removal steps in this procedure may contain installation details.
  1. G08619728
  2. WARNING: Carefully read cautionary information on product label. For emergency medical information seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.

    Extract the fluid with a syringe.

    G08619729
  3. G08619730
  4. With the vehicle in NEUTRAL, position it on a hoist. Refer to JACKING & LIFTING .
  5. Remove the RH front fender splash shield. Refer to FRONT END BODY PANELS .
  6. G08619731
  7. G08619732
    • To install, tighten to 9 Nm (80 lb-in).
      G08619733
  9. NOTE: Front bumper cover removed for clarity.
    • To install, tighten to 9 Nm (80 lb-in).
      G08619734
  10. G08619735
  11. NOTE: Do not operate the washer pump prior to filling the washer reservoir. Failure to follow this instruction may result in premature washer pump failure.

    To install, reverse the removal procedure.

    • Fill the washer reservoir with washer fluid.
scientia non olet · About LEMON Manuals