Removal and Installation

NOTE: For component identification and locations, refer to SEAT - EXPLODED VIEW, THIRD ROW .

Remove the 2 screw and pull the cushion handle out of the pocket.
Separate the pivot release cable and casing and remove the pivot release handle.
Remove the 2 screws on each side at the bottom of the load floor panel.
Pull out to release the retainers and remove the load floor panel.
- Use a suitable tool to disengage the load floor from the seat.
Remove the screw, release the tab and remove the floor latch cover.
Release the cushion trim cover retainers from the cushion frame.

Fig 1: Locating Cushion Trim Cover Retainers
Courtesy of FORD MOTOR CO.
Detach and remove the cushion cover.
To install, reverse the removal procedure.