LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2014 >> Flex SEL, FWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seat System - Seats >> Diagnosis And Testing >> Seating >> Pinpoint Tests >> Pinpoint Test AM: DTC B106E, B106F >> Pinpoint Test Am: DTC B106E, B106F

Pinpoint Test Am: DTC B106E, B106F

NOTE: If DTC B106F is present and the Driver Seat Module (DSM) is to be replaced, the fault condition must be corrected first. Failure to correct the fault condition first may cause damage to the new DSM  , resulting in a repeat repair.
  1. AM1 REVIEW THE DTCs 
    • Review the DTCs from the DSM  self-test.

    Is only DTC B106F present? 

    • Yes  : INSTALL a new DSM  . REFER to DRIVER SEAT MODULE (DSM)  in this article. TEST the system for normal operation.
    • No  : CORRECT any DTCs present other than DTC B106E (DTC B106F may also be present). REFER to DTC CHARTS  in this article. After the repair, GO to AM2  .
  2. AM2 CARRY OUT THE DSM SELF-TEST 
    • Carry out the DSM  self-test.

    Is only DTC B106F present? 

    • Yes  : INSTALL a new DSM  . REFER to DRIVER SEAT MODULE (DSM)  in this article. TEST the system for normal operation.
    • No  : The system is operating correctly at this time. The concern was caused by a fault in one of the output circuits, which is no longer present.
scientia non olet · About LEMON Manuals