Pinpoint Test G: "Active Park Assist Fault" Message Is Displayed In The CENTERSTACK Infotainment Display

G1 CHECK THE PAM DTCs
- Using a scan tool, perform the PAM self-test.
Are any PAM DTCs recorded?
- Yes : REFER to DTC CHARTS .
- No : GO to G2 .
G2 CHECK THE PSCM DTCs
- Using a scan tool, perform the PSCM self-test.
Are any PSCM DTCs recorded?
- Yes : REPAIR all PSCM DTCs. REFER to STEERING SYSTEM .
- No : GO to G3 .
G3 CHECK THE SCCM DTCs
- Using a scan tool, perform the SCCM self-test.
Are any SCCM DTCs recorded?
- Yes : REPAIR all SCCM DTCs. REFER to STEERING COLUMN SWITCHES .
- No : GO to G4 .
G4 CHECK ABS MODULE DTCs
- Using a scan tool, perform the ABS module self-test.
Are any ABS module DTCs recorded?
- Yes : REPAIR all ABS module DTCs. REFER to ANTI-LOCK BRAKE SYSTEM (ABS) AND STABILITY CONTROL .
- No : GO to G5 .
G5 CHECK THE PCM DTCs
- Using a scan tool, perform the PCM self-test.
Are any PCM DTCs recorded?
- Yes : REPAIR all PCM DTCs. REFER to ELECTRONIC ENGINE CONTROLS .
- No : GO to G6 .
G6 CHECK THE IPC DTCs
- Using a scan tool, perform the IPC self-test.
Are any IPC DTCs recorded?
- Yes : REFER to INSTRUMENTATION, MESSAGE CENTER, AND WARNING CHIMES . REPAIR all IPC DTCs.
- No : GO to G7 .
G7 CHECK THE BCM DTCs
- Using a scan tool, perform the BCM self-test.
Are any BCM DTCs recorded?
- Yes : REFER to MULTIFUNCTION ELECTRONIC MODULES . REPAIR all BCM DTCs.
- No : GO to G8 .
G8 CHECK FOR CORRECT PAM OPERATION
- Disconnect and inspect the PAM connector.
- Repair:
  - corrosion (install new connector or terminals - clean module pins)
  - damaged pins - install new terminals/pins
  - pushed-out pins - install new pins as necessary
- Reconnect the PAM connector. Make sure it seats and latches correctly.
- Operate the system and determine if the concern is still present.
Is the concern still present?
- Yes : CHECK OASIS for any applicable TSBs. If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no TSBs address this concern, INSTALL a new PAM . REFER to PARKING AID - AUDIBLE .
- No : The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.