| B115E:01 |
Camera Module: General Electrical Failure |
DTC B115E:01 sets in the BCM
when the video camera status indicates corrupted data with in the video camera. CLEAR the DTCs. REPEAT the self-test. If DTC B115E:01 is retrieved again, INSTALL a new video camera. REFER to VIDEO CAMERA . |
| B115E:08 |
Camera Module: Bus Signal/Message Failure |
GO to PINPOINT TEST A . |
| B115E:49 |
Camera Module: Internal Electronic Failure |
CLEAR the DTCs. REPEAT the self-test. If DTC B115E:49 is retrieved again, INSTALL a new video camera. REFER to VIDEO CAMERA . |
| B115E:55 |
Camera Module: Not Configured |
DTC B115E:55 sets in the BCM
when the video camera is not configured. The video camera needs to be configured through the BCM
. CARRY OUT the video camera configuration using a scan tool under Body > RVC configuration. |
| All other DTCs |
- |
REFER to
MULTIFUNCTION ELECTRONIC MODULES
. |