Symptom Chart
Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to Diagnostic Methods in
SERVICE INFORMATION
for information about these practices.
SYMPTOM CHART
| Condition |
Possible Sources |
Action |
- A module does not respond to the scan tool.
|
- Fuse
- Wiring, terminals or connectors
- PAM
|
|
- The parking aid is inoperative/does not operate correctly
|
- Refer to the Diagnostic Routine
|
|
- Continuous or intermittent tone when no obstacles or fault codes are present (certain obstacles may not be detected or recognized due to their shape, size or material)
|
- Dirty or iced over parking aid sensor(s)
|
- CLEAN the rear bumper and sensors with high-pressure water.
|
- Parking aid sensor bezel(s) or parking aid sensor(s) locked into the rear bumper incorrectly
|
- REMOVE and correctly INSTALL the parking aid sensor(s) and or bezel(s) as necessary.
|
- Parking aid sensors are not aligned correctly
|
|
- The audio output does not reduce when the parking aid tone sounds
|
- Refer to the Diagnostic Routine
|
|
- The reverse parking aid menu is not available in the Instrument Panel Cluster (IPC) message center and cannot be deactivated
|
|
- VERIFY that a MyKey® is in use.
|