Pinpoint Test E: The Engine Does Not Start

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

E1 CHECK FOR COMMUNICATION WITH THE PCM AND THE BCM
- Carry out the network test using the scan tool.
- Does the scan tool establish communication with the PCM and the Body Control Module (BCM)?
- Yes : GO to E2.
- No : To diagnose the module that is not communicating with the scan tool, REFER to MODULE COMMUNICATIONS NETWORK .
E2 CHECK FOR BCM DTCs
- Enter the following diagnostic mode on the scan tool: BCM Self-Test.
- Are any BCM DTCs present?
- Yes : REFER to the BCM DTC Chart .
- No : The no-start condition is not caused by PATS. REFER to the INTRODUCTION -- GASOLINE MODELS or INTRODUCTION - 6.7L DIESEL ENGINE -- F250-F550 SUPER DUTY PICKUPS , and SERVICE INFORMATION to diagnose the cause of the no-start condition.