LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2014 >> F-150 Limited, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 153 (Parking Brake System - Parking Brake & Actuation - F150) >> Diagnosis And Testing >> Parking Brake >> Pinpoint Tests >> Pinpoint Test A: The Parking Brake Does Not Apply >> Pinpoint Test A: The Parking Brake Does Not Apply

Pinpoint Test A: The Parking Brake Does Not Apply

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. A1 CHECK THE PARKING BRAKE CONTROL 
    • Press the parking brake control pedal.
    • Does the parking brake control pedal move? 
      • Yes  : GO to A2.
      • No  : GO to  A5.
  2. A2 CHECK FOR BROKEN CABLES 
    • Have an assistant press and release the parking brake pedal to help isolate disconnected cables or cables that do not move.
    • Inspect the following items for damage and correct connections.
      • Front cable and conduit
      • LH rear cable and conduit
      • RH rear cable and conduit
      • Rear cable brackets
    • Are the cables in good condition? 
      • Yes  : GO to A3.
      • No  : CONNECT the cable(s) or INSTALL new parking brake component(s) as necessary. TEST the system for normal operation.
  3. A3 CHECK THE PARKING BRAKE SHOES, ACTUATOR LEVERS AND HARDWARE 
    • Remove the rear brake disc, REFER to REAR DISC BRAKE . Inspect the parking brake shoes, actuator levers and hardware.
    • Are the parking brake shoes, actuator levers and hardware in good condition? 
      • Yes  : GO to A4.
      • No  : INSTALL new components as necessary. REFER to PARKING BRAKE SHOES  . TEST the system for normal operation.
  4. A4 CHECK THE PARKING BRAKE SHOE ADJUSTMENT 
  5. A5 ISOLATE THE PARKING BRAKE CONTROL AND FRONT PARKING BRAKE CABLE 
    • Disconnect the front parking brake cable from the RH rear parking brake cable at the cable union.
      Fig 1: Identifying Cable Union Of Front Parking Brake Cable And RH Rear Parking Brake Cable
      G06072887Courtesy of FORD MOTOR CO.
    • Press the parking brake control pedal.
    • Does the parking brake control pedal move? 
      • Yes  : GO to A6.
      • No  : GO to  A7.
  6. A6 ISOLATE THE REAR PARKING BRAKE CABLES 
    • Disconnect the LH cable from the RH conduit equalizer.
    • Disconnect the rear parking brake cables from the parking brake actuating levers.
    • While holding the cable conduit, attempt to slide the cable inside the conduit.
    • Does the cable slide freely inside the conduit? 
  7. A7 ISOLATE THE FRONT PARKING BRAKE CABLE 
      NOTE: The parking brake control take-up spool tab may need to be bent aside to allow the cable to be removed.
      Fig 2: Locating Parking Brake Control Take-Up Spool Tab
      G06167611Courtesy of FORD MOTOR CO.
    • Disconnect the front parking brake cable and conduit from the parking brake control.
    • While holding the cable conduit, attempt to slide the cable inside the conduit.
    • Does the cable slide freely inside the conduit? 
      • Yes  : INSTALL a new parking brake control. REFER to PARKING BRAKE CONTROL  . TEST the system for normal operation.
      • No  : INSTALL a new front parking brake cable. REFER to PARKING BRAKE CABLE - FRONT  . TEST the system for normal operation.
scientia non olet · About LEMON Manuals