Pinpoint Test H: The Odometer Is Inoperative

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

H1 CHECK FOR CORRUPTED NVM
- Ignition ON.
- Observe the message center display area.
- Does the odometer display ERROR?
  - Yes : INSTALL a new IPC. REFER to Instrument Panel Cluster (IPC) . TEST the system for normal operation.
  - No : GO to H2.
H2 RETRIEVE THE RECORDED DTCs FROM THE PCM KOEO SELF-TEST
- Check the recorded PCM DTCs from the Key ON Engine OFF (KOEO) self-test.
- Are any DTCs recorded?
  - Yes : REFER to ELECTRONIC ENGINE CONTROLS . TEST the system for normal operation.
  - No : GO to H3.
H3 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST
- Check for recorded IPC DTCs from the self-test.
- Are any DTCs recorded?
  - Yes : For DTC U0100:00, GO to Pinpoint Test AT .
    For DTC U3000:04, INSTALL a new IPC. REFER to Instrument Panel Cluster (IPC) . TEST the system for normal operation.
    
    For all other DTCs, REFER to DTC Charts .
  - No : INSTALL a new PCM. REFER to ELECTRONIC ENGINE CONTROLS . TEST the system for normal operation.