LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2014 >> F-150 FX2, 2D Pickup >> Repair and Diagnosis >> External Pages >> Different car >> Section 560 (Information Center Instrumentation, Message Center And Warning Chimes) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test BH : The Parking Brake Warning Chime Is Inoperative >> Pinpoint Test BH : The Parking Brake Warning Chime Is Inoperative

Pinpoint Test BH : The Parking Brake Warning Chime Is Inoperative

WARNING: This page is about a different car, the 2015 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

  1. BH1 CHECK THE SAFETY BELT WARNING CHIME OPERATION

    • Ignition OFF.
    • Ignition ON.
    • Unbuckle the driver safety belt.
    • Monitor the safety belt warning chime when the ignition is transitioned from OFF to RUN for 6 seconds.

    Does the safety belt warning chime operate for approximately 6 seconds? 

    Yes  GO to  BH2
    No  Refer to IPC Hardware Testing .

  2. BH2 CHECK THE BRAKE WARNING INDICATOR FOR CORRECT OPERATION

    • Apply the parking brake.
    • Observe the brake warning indicator.

    Does the brake warning indicator illuminate? 

    Yes  GO to  BH3
    No  GO to Pinpoint Test R 

  3. BH3 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST

    • Using a diagnostic scan tool, perform the IPC self-test.

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to DTC Chart: IPC .
    No  GO to  BH4

  4. BH4 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)

    • Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (CMDTCs).

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to: Communications Network .
    No  DIAGNOSE all BCM Diagnostic Trouble Codes (DTCs). REFER to: Body Control Module (BCM) .
scientia non olet · About LEMON Manuals