LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2014 >> F-150 FX2, 2D Pickup >> Repair and Diagnosis >> External Pages >> Different car >> Section 258 (Front Disc Brake System) >> Removal And Installation >> Front Brake Caliper Anchor Plate >> Removal

Front Brake Caliper Anchor Plate: Removal

WARNING: This page is about a different car, the 2013 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the brake pads. For additional information, refer to BRAKE PADS .
  2. Discard the specified component. Follow local disposal regulations.

    Apply the specified chemical with a spray can

    Clean the specified component with the specified material

    • To install, tighten the new bolts to 250 Nm (184 lb-ft).
      Fig 1: Cleaning Brake Caliper Anchor Plate With Specified Chemical
      G08336049Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals