LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2014 >> F-150 FX2, 2D Pickup >> Repair and Diagnosis >> External Pages >> Different car >> Section 184 (Fuel Charging System & Fuel Control System - 3.5L-GTDI - F150) >> Removal And Installation >> Fuel Pump Control Module >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the Fuel Pump Control Module (FPCM) electrical connector.
  2. Remove the 2 bolts and the FPCM.
    • To install, tighten to 9 Nm (80 lb-in).
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals