LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2014 >> F-150 FX2, 2D Pickup >> Repair and Diagnosis >> External Pages >> Different car >> Section 141 (Information Center - Instrumentation, Message Center, And Warning Chimes - F150) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test AO: The Key-In-Ignition Warning Chime Is Inoperative >> Pinpoint Test AO: The Key-In-Ignition Warning Chime Is Inoperative

Pinpoint Test AO: The Key-In-Ignition Warning Chime Is Inoperative

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. AO1 CHECK THE SAFETY BELT WARNING CHIME OPERATION 
    • Ignition OFF.
    • Unbuckle the driver safety belt.
    • Ignition ON.
    • Monitor the safety belt warning chime when the ignition switch is transitioned from OFF to RUN for 6 seconds.
    • Does the safety belt warning chime operate for approximately 6 seconds? 
  2. AO2 CHECK THE INTERIOR LAMPS OPERATION 
    • Open and close the driver door.
    • Observe the interior lamps.
    • Do the interior lamps operate correctly from the driver door? 
  3. AO3 RETRIEVE THE RECORDED DTCs FROM THE BCM SELF-TEST 
    • Check the recorded DTCs from the BCM self-test.
    • Is DTC B10F1:14 present? 
      • Yes  : GO to  AO4.
      • No  : GO to  AO6.
  4. AO4 CHECK THE KEY-IN-IGNITION INPUT CIRCUIT FOR VOLTAGE 
    • Ignition OFF.
    • Insert the key into the ignition cylinder.
    • Disconnect: BCM C2280B.
    • Measure the voltage between the BCM C2280B-34, circuit CDC30 (BU/GY), harness side and ground.
      Fig 1: Measuring Voltage Between BCM C2280B-34, Circuit CDC30 (BU/GY), Harness Side And Ground
      G07406190Courtesy of FORD MOTOR CO.
    • Is the voltage greater than 10 volts? 
      • Yes  : GO to  AO6.
      • No  : GO to  AO5.
  5. AO5 CHECK THE IGNITION SWITCH 
    • Ignition OFF.
    • Disconnect: Ignition Switch C250.
    • Carry out the ignition switch component test. Refer to OEM COMPONENT TESTING - F150 for component testing.
    • Is the ignition switch OK? 
      • Yes  : REPAIR circuit CDC30 (BU/GY) for an open. CLEAR the DTCs. REPEAT the self-test.
      • No  : INSTALL a new ignition switch. REFER to STEERING COLUMN SWITCHES . CLEAR the DTCs. REPEAT the self-test.
  6. AO6 CHECK FOR CORRECT BCM OPERATION 
    • Disconnect all the BCM connectors.
    • Check for:
      • corrosion
      • damaged pins
      • pushed-out pins
    • Connect all the BCM connectors and make sure they seat correctly.
    • Operate the system and verify the concern is still present.
    • Is the concern still present? 
      • Yes  : INSTALL a new BCM. REFER to MULTIFUNCTION ELECTRONIC MODULES . TEST the system for normal operation.
      • No  : The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector.
scientia non olet · About LEMON Manuals