LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2014 >> F-150 FX2, 2D Pickup >> Repair and Diagnosis >> External Pages >> Different car >> Section 118 (Engine Mechanical - 3.7L - F150) >> In-Vehicle Repair >> Engine Oil Pressure (EOP) Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the Engine Oil Pressure (EOP) switch electrical connector.
  2. Remove the EOP switch.
    • To install, tighten to 14 Nm (124 lb-in) then an additional 180 degrees.
  3. To install, reverse the removal procedure.
    • Apply thread sealant with PTFE to the EOP switch threads prior to installation.
scientia non olet · About LEMON Manuals